school.
commute.
work.
repeat.

Search This Blog

First ride home

on November 04, 2019

Get link
Facebook
X
Pinterest
Email
Other Apps

It's a bit blurry but everything's bolted on, connected and wired up. Time to ride it home.

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Front wheel weirdness

So there's a few weird things going on with my Gazelle front wheel. Weird things being that it uses parts that are either bespoke to Gazelle or really hard to find if they are even available as spares. First is that the brake shoes are completely different to Sturmey Archer ones. Not only are they made of pressed sheet steel, Sturmey ones are cast - you can see the ones I broke in an earlier post, but the pivot is a different size and the cam is a different width. Next the bearing race uses different size and therefore also different number of ball bearings. There's a picture below of a Sturmey Archer rear cone next to my Gazelle front cone showing the difference in size. Looking online spare front wheel bearings for a Sturmey archer drum hub are too big and too few https://www.dutchbikebits.com/sturmey-archer-front-axle Mine has 11 balls at approx 4.75mm diameter Ages ago there was an old Gazelle going spare which had an almost identical front hub to mine externally but insid...

Cycle Trailer - Follow Me Tandem

I'd been told about these a few years ago and now it's time to fit one. The issue I have is that there is no "off the shelf" mount that will allow me to still use the bicycles rear stand in combination with my bicycles hub gears. With a cassette and derailuer set up the Follow Me Tandem fittings replace the bolts on the end of the rear axle, and there is an attachment to enable fitting to bicycles with hub gears but this won't fit because of the design of my bike rack and integrated flip down stand, which I want to keep too. My plan is to machine some of my own mounts out of stainless steel and bolt them to the vertical tubes of the bike rack support. Here's some pictures of the quick release axle and the mounts for the Follow Me Tandem Machining on the lathe Cutting the slots on the mill Part way through the first one Final pair with one disassembled to show how they will bolt together over the bike rack

2000 miles

Powered by Blogger

First ride home

Comments

Post a Comment